| |
| Table construction |
Sandwich
composite, finished with coated aluminum on top and bottom surfaces |
| Drive mode |
1 micro
stepping 3 Amp stepper motor with direct gear drive |
| Motion control |
Automatic
computer drive or manual command rotation |
| Maximum diameter |
21.5" or 550 mm
- 36" or 90mm (Standard - Industrial cutters) |
| Weight capacity |
37 lbs -
to 300 lbs (Standard - Industrial cutters) |
| Maximum half load speed |
2 full turns /
minute |
| Minimum rotational angle |
0.225°
controlled by AFC software |
| Mounting |
Mounted as
integrated component of Aixia |
| Setup and training |
Included in
North America when purchase at same time as Aixia cutter |
| Design software |
Any 2D software
capable of exporting HPGL files |
| Power required |
110 Volt / 60
Hz or 220 Volt / 50 Hz; 4 Amp |
| Operating Environment |
Temperature:
32°F - 104°F or 0 - 40°C; Humidity: 95% (non-condensing) |
| Computer operating system |
Windows 95, 98,
NT 4.0, 2000, XP |
| Electronic controller |
Microprocessor
controlled motor drive |
| Warranty |
10 year when
purchased as original equipment |
| Options available |
Shapeable Wire
Tool |
